News /
What matters should be paid attention to when the glass steel water tank is being debugged?
Classification:Tank encyclopedia 2019-05-21
The application of fiberglass water tank has been gradually recognized. But will tell to novice, glass steel cistern is in the process that installation needs to undertake debugging, when installing glass steel cistern how should do well debugging job? Below by small make up to introduce for you in detail.
Glass steel tank before installation, must check the tank concrete foundation surface is flat, and then in accordance with the size of the tank bottom plate, will have cut good channel steel welding combination, and then began to assemble the tank plate, plate and plate between the clamp seal strip to bolt connection. The bottom plate is assembled and laid flat on the channel steel base, and then the sides are combined and connected with the bottom. After the connection, start the installation brace, first at four sides of the cross point brace plate under four boards rely on a good drill hole Angle, with four pillars on silk, through the internal and external brace plate, the four block powder, between screw and plate to rubber gasket seal, pull the pull the ends of the ribbon threaded through the middle hole, stiffened plates with a nut brace plate tension within two blocks.
Small share of the glass fiber reinforced plastic water tank in debugging problems at this point, and hope to have some help, if you want to buy glass fiber reinforced plastic water tank, you can contact our customer service personnel, can directly to our company on-the-spot investigation, thank you for your support, more news consulting small make up will continue to update, thanks for watching.