新闻中心

Contact us

Shandong Chuangyi Water Supply Equipment Co.,Ltd

TEL: 0086-534-2106530

FAX: 0086-534-2106532

E-mail: macky@sdzhuen.com

Skype: ma.macky

Alibaba Website: cnsdchuangyi.en.alibaba.com

News /

The comparison between the enamel steel tank and the plastic plate water tank

Classification:Tank encyclopedia  2019-05-21

Assembly type combination enamel steel plate water tank

The modular enamel steel tank is a new type of water tank that is fired and assembled from delta 3-delta 5 steel plates using HSC enamel as the base and surface glaze. Its porcelain layer has a higher mechanical impact resistance, which is 4-5 times higher than that of ordinary enamel vessels. It has the advantages of acid resistance, alkali resistance, no permeability, no leakage, no corrosion, no deformation, and water quality cleaning and sanitation. It is an ideal water tank for storing hot and cold water. The quality of glass and enamel products by ministry of light industry of China and Beijing health and epidemic prevention department have been tested.

The water storage volume of the fabricated enamel steel plate water tank is 1.0m3-64m3, which is mainly used for expansion and condensation water tank of heating system. Fire fighting, storage tank; Construction, geological exploration and national defense engineering.

1. civil construction, first make the support, the tank around and at the bottom of the standard block between the joints to be located in the support.

2. During installation, the tank body and wall as well as the bottom and top of the tank must be provided with maintenance channels. The tank body and wall shall be no less than 0.7 meters, and the bottom and top of the tank shall be no less than 0.6 meters.

3. After assembly, close the outlet and drain pipes, open the inlet pipes, and check to fill the water while discharging. It is qualified to be leakproof for two hours.

4. The water tank shall be cleaned regularly and sundries shall not be flushed into the box when water is tested. Water storage tank. When cistern serves as hot cistern, rubber mat changes heat resisting rubber mat.

Two, composite spray steel plate water tank

Composite plastic spraying steel plate water tank, the surface using electrostatic spraying process for special treatment of the production of water tank board, high strength, color paint is not easy to fall off, corrosion resistance, anti-aging, no pollution, low cost, more environmental protection, beautiful appearance. Every face

Use 12 screws to connect, increase the density between the screws, greatly reduce the chance of water tank leakage. Field assembly is light, flexible, easy to clean, completely broken by sunlight, no algae breeding, and always keep water clean. The tank is ready for storage

Store cold water, also can store hot water, no leakage, no deformation.

Plastic spraying steel plate tank electrostatic spraying process principle: electrostatic powder spraying equipment (electrostatic spray molding machine) powder coating to the surface of the workpiece, under the electrostatic effect, the powder will be evenly adsorbed on the surface of the workpiece, forming a powdery coating; Powder coating after high temperature baking leveling curing, into different effects (powder coating of different kinds of effects) of the final coating. After a long time of development and application, the product has a good reflection effect. Due to the general, standardized and serialized development of the product, the product quality has a reliable guarantee. Compared with enamel and hot-dip galvanized steel tank, the cost is lower and the service life is longer.



Enterprise online
Enterprise online
Hotline

0086-18505448866

0086-534-2106530

二维码

Scan
Adding Business Wechat